246 Using the Remote Control Panel Utility (EPL-6200 only)
Accessing the Remote Control Panel utility
Before you launch the Remote Control Panel utility, remember
that you can use the following keys on your keyboard to navigate
within the utility:
To start the Remote Control Panel utility, type the following at
the DOS prompt and press the Enter key. (If you changed the
default directory during installation, type that directory instead.)
C:\EPSONRCP\EPRCP
If the Remote Control Panel utility was not able to communicate
with the printer in bidirectional mode, it returns the following
Error dialog box. If bidirectional communication is possible, skip
this section and go directly to “Mode-Select dialog box” on page
248.
TAB: Advances to the next menu
Shift+TAB: Moves to the previous menu
Arrow keys: Moves to options within menus
ENTER: Registers the selection (executes the operation)
To Next Page
Loading...
