268 Using the Remote Control Panel Utility (EPL-6200 only)
Join
Allows you to define how the ends of lines should be joined. The
default setting is Mitered. See the illustrations below.
Pen0, Pen1, Pen2, Pen3, Pen4, Pen5, Pen6
Allows you to select the line width. You can select a value from
0.05 mm to 5.00 mm, in increments of 0.05 mm. Pen3 to Pen6 are
available only in GLlike mode.
NONE MITERED
MITEREDBEVELED
TRIANGULAR
ROUND BEVELED
To Next Page
Loading...
