Replacing Consumable Products 319
9
9
9
9
9
9
9
9
9
9
9
9
7. Hold the photoconductor unit’s casing by its handle and
insert it into the printer. Slide it gently into the opening until
it locks into place.
8. Close the front cover until it clicks shut.
You should reset the counter after replacing the photoconductor
unit. The photoconductor counter for the EPL-6200 can be reset
by using the buttons on the control panel or the printer driver,
while that for the EPL-6200L can be reset only through the printer
driver.
To Next Page
Loading...
