320 Replacing Consumable Products
For EPL-6200, make sure that the printer is turned off, and then
hold down the N Start/Stop and the @ Information buttons on
the control panel simultaneously while turning on the printer.
Continue holding down these buttons until the Ready (green)
and Error (red) lights turn on. The photoconductor counter is
cleared.
To reset the photoconductor counter using the printer driver, see
“Resetting the photoconductor counter” on page 61 (Windows)
or “Resetting the photoconductor counter” on page 281
(Macintosh).
To Next Page
Loading...
