Troubleshooting 345
11
11
11
11
11
11
11
11
11
11
11
11
For detailed information on the manual feed mode, see “Manual
feed slot (EPL-6200 only)” on page 15, and for instructions on how
to load paper into the manual feed slotF, see “Manual feed slot
(EPL-6200 only)” on page 26.
Control panel: m light flashing, Error light on
There is no paper in the specified paper source. Load paper of the
size specified in the printer driver into the paper source. See
“Paper Sources” on page 14 and “Loading Paper” on page 15 for
instructions on loading paper.
Control panel:
v light on, Error light flashing (slowly)
The developer cartridge is out of toner. Replace the developer
cartridge by following the instructions under “Developer
Cartridge” on page 306. To clear this error and print a single sheet,
press the N Start/Stop button on the control panel. After that, this
error will occur again until the developer cartridge is replaced.
Control panel: m and Error lights flashing
The paper loaded in the paper source does not match the required
paper size. Replace with paper of the correct size and press the N
Start/Stop button.
Paper Out
Toner Out
Printing on Incorrect Paper Size
To Next Page
Loading...
