346 Troubleshooting
Control panel:
~ light on, Error light flashing
The required time to process the print data exceeded the print
engine speed because the current page is too complex. Press the
N Start/Stop button to resume printing or press the q Job
Cancel button to cancel the print job. If this message appears
again, set Page Protect to On. If you continue to receive this
message when printing a particular page, try simplifying the page
by limiting the number of graphics or reducing the number and
size of fonts.
You can also add more memory to the printer for a more
permanent solution as described in “Memory Module” on page
295.
Control panel:
~ light on, Error light flashing
The printer has insufficient memory for the current task. The
document was not printed. To correct the error, press the N
Start/Stop button. To cancel the print job, press the q Job
Cancel button.
The next time you print the document, it may be necessary to
reduce the number or size of fonts, reduce the number or size of
graphics, or lower the resolution. You can also add more memory
to the printer.
Page contains too much data to process
Insufficient Memory for Current Task
To Next Page
Loading...
