Epson EPL-6200 - Page 370

Troubleshooting 353
11
11
11
11
11
11
11
11
11
11
11
11
Control panel: Error light on
A controller error has been detected. Turn off the printer, wait 5
seconds and then turn it back on. If all the lights come on again,
turn off the printer, unplug the power cord, and contact a
qualified service representative.
Control panel: Ready and Error lights flashing
A print engine error has been detected. Turn off the printer, wait
5 seconds and then turn it back on. If the lights come on again,
turn off the printer, unplug the power cord, and contact a
qualified service representative.
Control panel: Ready light flashing, Error light on
A protocol error has been detected. Turn off the printer, wait 5
seconds and then turn it back on. If the lights come on again, turn
off the printer, unplug the power cord, and contact a qualified
service representative.
Service Required (controller error)
Service Required (engine error)
Service Required (protocol error)
Output Paper Jam