360 Troubleshooting
To temporarily dismiss the warning, click Close on the EPSON
Status Monitor 3 window that appears. Resetting the
photoconductor unit also clears the warning.
Control panel: Ready light flashing (flashes at longer intervals
than usual)
Indicates that the developer cartridge is nearly out of toner.
Prepare a new developer cartridge to replace the current one. See
“Developer Cartridge” on page 306 for instructions.
Control panel: Ready light flashing (flashes at longer intervals
than usual)
This is a warning to inform you that the installed developer
cartridge is not a genuine EPSON product. The use of such
products may damage the printer and cause the print quality to
decrease. Remove the currently installed cartridge and replace it
with a genuine EPSON cartridge by following the instructions
under “Developer Cartridge” on page 306.
To temporarily dismiss the warning, click Close on the EPSON
Status Monitor 3 window that appears.
Toner Low
Installed Developer Cartridge is Not a Genuine EPSON Product
Warning
Sleep mode
To Next Page
Loading...
