Using the Printer Driver For Windows 81
3
3
3
3
3
3
3
3
3
3
3
3
Output Protocol
Specify the protocol that the printer will use for print jobs. The
options are ASCII, TBCP, and Binary.
Note:
Binary can only be used with AppleTalk. However, when AppleTalk is
in use, TBCP is unavailable.
If ASCII is selected, print data is sent in the ASCII (7-bit) format,
which may take longer to print, but which can be sent through
any I/O channel, including serial, parallel, and Ethernet.
If you select TBCP (Tagged Binary Communications Protocol), all
data except for special control characters is sent in binary (8-bit)
format. The binary formats can be sent over parallel or serial
communications ports and are faster then sending data in the
ASCII format.
Note:
The Tagged binary communications protocol cannot be used with
AppleTalk.
Send CTRL-D Before Each Job
Specify whether a CTRL+D character should be sent at the
beginning of every PostScript document. CTRL+D at the
beginning-of-file (BOF) will reset your printer to its default
settings to ensure that prior print jobs will not affect the current
print job. However, activating this setting may cause the print job
to fail if it is connected through a network instead of the parallel
or serial interface.
Send CTRL-D After Each Job
Specify whether a CTRL+D character should be sent at the end of
every PostScript document. CTRL+D at the end-of-file (EOF) will
reset your printer to its default settings to ensure that the current
print job will not affect future print jobs. However, activating this
setting may cause the print job to fail if it is connected through a
network instead of the parallel or serial interface.
To Next Page
Loading...
