Problem Solver 137
R4CC530
long.bk Rev. E
A5 size TROUB.fm
6/23/03
R
Proof Sign-off:
ABE J. Hashimoto, S. Yamamoto
H. Kimura
S. Halvorson
5
5
5
5
5
5
5
5
5
5
5
5
Cause What to do
Paper is too long. Press the Load/Eject button to eject the
sheet. Make sure the page length of your
paper is within the range specified for
single-sheet paper in “Paper” on page
213. Also check and adjust the paper size
setting in your application or printer
driver.
The paper does not feed properly with the optional cut-sheet
feeder.
Cause What to do
The cut-sheet feeder is not
installed properly.
Reinstall it as described in “Installing the
cut-sheet feeder” on page 172.
Too many sheets are loaded in
the cut-sheet feeder. You
cannot load more than 150
sheets of paper in the
high-capacity cut-sheet feeder.
Load less than 150 sheets of paper. See
“Cut-Sheet Feeder” on page 171 for
more information.
The edge guides of the
cut-sheet feeder are not
positioned correctly.
Align the left edge guide with the arrow
mark, then move the right edge guide to
match your paper’s width.
There is only one sheet left in
the bin.
Add more paper to the cut-sheet feeder.
The printer does not load continuous paper or does not feed it
properly.
Cause What to do
The paper release lever is not
set correctly.
Set the paper release lever to the position
for the paper source you want to use. See
“Setting the Paper Release Lever” on
page 14 for instructions.
To Next Page
Loading...
