Problem Solver 145
R4CC530
long.bk Rev. E
A5 size TROUB.fm
6/23/03
R
Proof Sign-off:
ABE J. Hashimoto, S. Yamamoto
H. Kimura
S. Halvorson
5
5
5
5
5
5
5
5
5
5
5
5
The printout has extra blank lines between lines of text.
Cause What to do
Two line feed commands are
being sent at the end of each
line of text, because the
printer’s auto line feed setting
is on.
Turn off the auto line feed setting using
the printer’s default-setting mode. See
“Changing default settings” on page
122.
The line space setting in your
application software is
incorrect.
Adjust the line space setting in your
application software.
The printer prints strange symbols, incorrect fonts, or other
inappropriate characters.
Cause What to do
Your printer and computer are
not communicating correctly.
Make sure that you use the correct
interface cable and that the
communications protocol is correct. See
“Electronic” on page 210 and your
computer documentation.
The wrong character table is
selected in your software.
Select the correct character table using
your software or the default-setting
mode. The character table setting in your
software overrides settings made in the
default-setting mode.
The printer you want to use is
not selected in your software
Choose the correct printer from the
Windows desktop or in your application
before printing.
Your application software is
not configured correctly for
your printer.
Make sure that your application
software is configured correctly for your
printer. See your application
documentation. If necessary, install or
reinstall the printer driver software as
described in the Setup Sheet.
To Next Page
Loading...
