Epson LQ-590 - Selecting a Font and Pitch

Control Panel 115
4
4
4
4
4
4
4
4
4
4
4
4
Selecting a Font and Pitch
You can select one of the printer’s fonts and pitch by using the
buttons on the printer’s control panel, as described below.
Note:
❏ You can select other fonts than the seven fonts on the control panel
by selecting Others. Other fonts can be set in the default setting
mode. See “About Your Printer’s Default Settings” on page 117 for
more information.
❏ Settings you make in application programs usually override settings
you make from the printer’s control panel. For best results, use your
application to select a font and make other settings.
jPause button
❏ Stops printing temporarily, and resumes printing
when pressed again.
❏ When held down for three seconds, enters the Micro
Adjust mode. When pressed again, exits the Micro
Adjust mode.
k Paper Out light
❏ On when no paper is loaded in the selected paper
source or paper is not loaded correctly.
❏ Flashes when paper has not been fully ejected or a
paper jam has occurred.