Epson LQ-590 - EPSON Status Monitor 3

Problem Solver 133
5
5
5
5
5
5
5
5
5
5
5
5
O = on, F = flashing
••• = short series of beeps (three beeps), ••••• = long series of beeps (five beeps)
Note:
The printer beeps once if you press a control panel button when the
corresponding function is not available.
EPSON Status Monitor 3
EPSON Status Monitor 3 provides status messages and a graphic
display showing the current status of the printer.
F Paper Out
O Pause
••• A single sheet of paper is not fully ejected.
Press the Load/Eject button to eject the sheet.
••• Continuous paper is not fed to the standby
position.
Tear off the printed page at the perforation;
then press the Load/ Eject button. The printer
feeds the paper to the standby position.
••• Paper is jammed in the printer.
To clear the paper jam, see “Clearing Paper
Jams” on page 154.
F Pause — The print head is overheated.
Wait for a few minutes; the printer resumes
printing automatically once the print head
cools.
F Paper Out
F Pause
FF Tear Off/Bin
FFF Font
FFF Pitch
••••• An unknown printer error has occurred.
Turn off the printer and leave it off for several
minutes; then turn on the printer again. If the
error recurs, contact your dealer.
State of panel
lights
Beep
pattern
Problem
Solution