118 Control Panel
Understanding default settings
This section describes the settings and options available in the
default-setting mode. These settings are shown in the following
table and explained in detail after the table.
To access and change a setting, see “Changing default settings”
on page 124.
Default-setting mode
Menu Values (default in bold)
Print the current settings* Execute
Page length for front tractor Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5,
11, 70/6, 12, 14, 17
Page length for rear tractor Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5,
11, 70/6, 12, 14, 17
Skip over perforation Off, On
Auto tear off Off, On
Auto line feed Off, On
Print direction Bi-D, Uni-D, Auto
Software ESC/P2, IBM PPDS
0 slash 0, (the zero character with a slash)
I/F (interface) mode Auto, Parallel, USB, Option
Auto I/F (interface) wait time 10 seconds, 30 seconds
Parallel I/F bidirectional mode Off, On
Packet mode Auto, Off
Auto CR (IBM PPDS)*** Off, On
A.G.M. (IBM PPDS)*** Off, On
To Next Page
Loading...
