126 Control Panel
Note:
You cannot change the setting value to the previous item. You have
to press the Set button until the value you want is selected.
7. When you finish making settings, press the Menu (Pitch and
Tear Off/Bin) buttons.
The Menu lights (both of the Tear Off/Bin lights) turn off and
the printer exits the default-setting mode.
The settings you made is saved as new default value.
Note:
If you turn off the printer prior to exiting default-setting mode, any
changes you may have made are canceled and not saved.
Lock-Out Mode
You can restrict the use of buttons on the control panel by using
the lock-out mode. In the basic setting, you can only use the
Pause, Load/Eject and Tear Off/Bin buttons, when the lock-out
mode is on.
Turning on or off the lock-out mode
You can turn on or off the lock-out mode easily by using buttons
on the control panel.
Follow these steps to turn on the lock-out mode:
1. Make sure the printer is turned off.
To Next Page
Loading...
