Paper Handling 53
2
2
2
2
2
2
2
2
2
2
2
2
Loading Special Paper
Multipart forms
You can use carbonless multipart forms of up to five parts (four
copies on top of the original). Make sure you set the
paper-thickness lever to the proper position based on the number
of layers in your form. See “Adjusting the Paper-Thickness Lever”
on page 12 for instructions.
Continuous multipart forms
Except for setting the paper-thickness lever, you load continuous
multipart forms the same way as ordinary continuous paper. See
“Loading Continuous Paper” on page 14 for detailed instructions.
Note:
❏ Be sure your multipart forms do not exceed 0.39 mm (0.015 inch)
in thickness.
❏ Do not load paper that is curled or has been folded.
❏ Thick paper, such as multipart forms with five parts, requires a
straight paper path to avoid paper jams. Load thick paper in the front
or bottom slots.
Single-sheet multipart forms
When loading single-sheet multipart forms, you need to use the
front paper entry slot with the front sheet guide and front paper
guide installed on your printer, because thick paper, such as
multipart forms with five parts, requires a straight paper path to
avoid paper jams.
To load single-sheet multipart forms, follow the instructions in
“Loading paper in the front sheet guide or front paper guide” on
page 195.
To Next Page
Loading...
