Epson LX 300+II Reference Guide

Paper Handling 25
Adjusting the tear-off position
If your paper’s perforation is not aligned with the tear-off edge,
you can use the Micro Adjust mode to move the perforation to
the tear-off position. Follow these steps:
1. Make sure the Tear Off (Font) lights are flashing. You may
need to press the Tear Off (Font) button to advance the
paper to the tear-off position.
2. Open the printer cover.
3. Hold down the Pause button for about three seconds. The
printer beeps and the Pause light begins to flash as the
printer enters Micro Adjust mode.
4. Press the LF/FF D button to feed the paper backward, or
press the Load/Eject U button to feed the paper forward,
until the paper perforation is aligned with the tear-off edge
on the paper tension unit.
Note:
The printer has a minimum and a maximum tear-off position. If
you try to adjust the tear-off position beyond these limits, the
printer beeps and stops moving the paper.
Tear-off edge

Epson LX 300+II Specifications

Power

rated voltage	120V AC
input voltage range	99 to 132V, 198 to 164V
rated frequency range	50 to 60 Hz
input frequency range	49.5 to 60.5 Hz
power consumption	Approx. 23W (ISO/IEC 10561 Letter Pattern)

Performance

print speed high speed draft	337 cps (12 cpi)
print speed draft	225 cps (10 cpi)
print speed near letter quality	56 cps (10 cpi)
sound level	49 dBA (ISO 7779 pattern)
mtbf	6, 000 POH (25% duty cycle)
print head life	400 million characters
ribbon life	3 million characters (draft, 10 cpi, 14 dots/character)

Weight and Dimensions

carton dimensions	14.5" x 17.6" x 8.6" (W x D x H)
carton weight	12.10 lb
height	6.26" (159 mm)
width	14.42" (366 mm)
depth	10.84" (275 mm)
weight	9.7 lb (4.4 kg)