Epson LX 300+II Reference Guide

Maintenance and Troubleshooting 97
Switching between the cut-sheet feeder and the push tractor
does not work properly
Using the pull tractor with the push tractor, continuous paper
does not feed properly
The desired paper type does not load.
Cause What to do
The paper release lever
may not be in the proper
position.
Pull the lever forward to load
continuous paper or push the lever back
to load single sheets.
Paper is feeding crooked or jams.
Cause What to do
The pull tractor and push
tractor sprockets are not
aligned correctly.
When using both tractors, make sure
that the sprockets on both are positioned
evenly.
The paper may have too
much slack.
Adjust the position of the sprockets to
take up any slack along the width of the
paper. Remove slack lengthwise by
rotating the paper feed knob.
The paper may be caught
on the edge guides.
Make sure that the paper guide is
installed over the paper and that the
edge guides are positioned correctly.

Epson LX 300+II Specifications

Power

rated voltage	120V AC
input voltage range	99 to 132V, 198 to 164V
rated frequency range	50 to 60 Hz
input frequency range	49.5 to 60.5 Hz
power consumption	Approx. 23W (ISO/IEC 10561 Letter Pattern)

Performance

print speed high speed draft	337 cps (12 cpi)
print speed draft	225 cps (10 cpi)
print speed near letter quality	56 cps (10 cpi)
sound level	49 dBA (ISO 7779 pattern)
mtbf	6, 000 POH (25% duty cycle)
print head life	400 million characters
ribbon life	3 million characters (draft, 10 cpi, 14 dots/character)

Weight and Dimensions

carton dimensions	14.5" x 17.6" x 8.6" (W x D x H)
carton weight	12.10 lb
height	6.26" (159 mm)
width	14.42" (366 mm)
depth	10.84" (275 mm)
weight	9.7 lb (4.4 kg)