Epson SC-S30600 Series User Manual

SC-S30600 Series Revision B
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 142
Confidential
10. Remove the three screws that secure the Pump Cap Unit.
B) Silver M4x8 S-tite screw with built-in washer: 3 pcs
11. Remove the two Waste Ink Tubes from the joint, and release the tubes from the
clamp.
12. To prevent ink from dripping, insert the tip of the Waste Ink Tube into the hole
shown below.
13. Pull the Pump Cap Unit frontward to disengage the hook, and remove the Pump
Cap Unit avoiding contact with the CR shaft or any other parts.
Figure 3-93. Removing the Pump Cap Unit
B
B
B
Hook
Clamp
Waste Ink Tube
Joint
Pump Cap Unit
Insert the tip of the tube

Epson SC-S30600 Series Specifications

General

Brand	Epson
Model	SC-S30600 Series
Category	Printer
Language	English