Setup & Operation 1. Safety
14 G6 Rev.21
1.7 Warning Labels
The Manipulator has the following warning labels.
The warning labels are attached around the locations where specific dangers exist.
Be sure to comply with descriptions and warnings on the labels to operate and maintain
the Manipulator safely.
Do not tear, damage, or remove the warning labels. Use meticulous care when handling
those parts or units to which the following warning labels are attached as well as the
nearby areas.
Location
Before loosening the base
mounting screws, hold the arm
and secure it tightly with a band
to prevent hands or fingers from
being caught in the Manipulator.
B
C
Hazardous voltage exists while
the Manipulator is ON. To avoid
electric shock, do not touch any
internal electric parts.
D
You can catch your hand or
fingers between the shaft and
cover when bringing your hand
close to moving parts.
* Manipulators with bellows do
not have this label for no danger
of your hand or fingers being
caught.
E
Be careful of the hand falling while
the brake release switch is being
pressed.
F
To Next Page
Loading...
