Epson Stylus C110 - Front Paper Guide

EPSON Stylus C110/C120/D120 Revision B
DISASSEMBLY/ASSEMBLY Disassembling Printer Mechanism 104
4.5.17 Front Paper Guide
 Part/Unit that should be removed before removing Front Paper Guide
Upper Housing/Lower Housing/Main Board Unit/Left Frame/Panel Unit/Front
Frame/Right Frame/CR Motor/CR Scale/Hopper/Main Frame Ashy./ASF Unit/Ink
System Unit/Star Wheel Holder Assy./EJ Roller
 Removal Procedure
1. Remove the screws (x2) that secure the Front Paper Guide.
Figure 4-82. Removing Front Paper Guide (1)
2. Release the hook (x1) of the Front Paper Guide, and remove it.
Figure 4-83. Removing Front Paper Guide (2)
C A U T I O N
When removing the Front Paper Guide, Be cautious not to damage
the rib on the upper surface of the Front Paper Guide.
Figure 4-81. Rib of the Front Paper Guide
Rib
Front Paper Guide
C.B.P. 3x10, F/Zn-3C (6±1kgfcm)
1
2
 When installing the Front Paper Guide, be cautious not to
damage the PF Roller.
 Make sure that the tip of the PGF Pad is put in the correct
position as shown in the figure below. It should not get caught
between the Front Paper Guide and the Base Frame.
Figure 4-84. Installing Front Paper Guide
 Tighten the screws in the order given in Figure 4-82.
A D J U S T M E N T
R E Q U I R E D
 After removing/replacing the Front Paper Guide, be sure to
perform the specified adjustment. See
Chapter 5 “
ADJUSTMENT” (p.107)
 After replacing the Front Paper Guide, be sure to perform the
required lubrication. See Chapter 6 “ MAINTENANCE”
(p.116)
Front Paper Guide
Hook
Tip of the PGF Pad
Correct Position Incorrect Position