Epson Stylus C110 - PF Encoder Sensor

EPSON Stylus C110/C120/D120 Revision B
DISASSEMBLY/ASSEMBLY Disassembling Printer Mechanism 90
4.5.8 PF Encoder Sensor
 Part/Unit that should be removed before removing PF Encoder Sensor
Upper Housing/Lower Housing/Main Board Unit/Left Frame/Panel Unit
 Removal Procedure
1. Peel off the acetate tape (x1) from the PF Encoder Sensor.
2. Release the PF Encoder FFC from the connector (x1) of the PF Encoder Sensor.
3. Remove the screw (x1) that secures the PF Encoder Sensor, and remove it.
Figure 4-45. Removing PF Encoder Sensor
Acetate Tape
PF Encoder FFC
C.B.P. 2.5x8, F/Zn-3C (4±1kgfcm)
PF Encoder Sensor
When installing the PF Encoder Sensor, be sure to attach the
acetate tape (x1) referring to the figure below.
Figure 4-46. Acetate Tape Position
Align here with edge of
the PF Encoder Sensor
30mm