Name: Epson Stylus C110
Brand: Epson
Rating: 5 (1 reviews)

To Next Page

To Previous Page

EPSON Stylus C110/C120/D120 Revision B

TROUBLESHOOTING Troubleshooting 62

• Operation

•–

When turning on the power, the power on

sequence is performed correctly. But,

when any printer job is sent to the printer,

a communication error is indicated with

STM3.

USB Cable

1. Check if the USB Cable is connected between the printer

and the PC.

1. Connect the USB Cable to the printer and the

PC.

Main Board Unit

1. Check if an correct model name is stored into the address

of the EEPROM on the Main Board.

1. Use the Adjustment Program to write the

correct value to the EEPROM address.

2. Check if the Panel FFC is connected to CN11 on the Main

Board.

2. Connect the Panel FFC to CN11 on the Main

Board.

Table 3-11. Check point for communication error according to each phenomenon

Occurrence timing

CR position

Detailed phenomenon

Defective unit/

part name

Check point Remedy

CN11

Panel FFC

Other manuals for Epson Stylus C110

Questions and Answers:

Need help?

Do you have a question about the Epson Stylus C110 and is the answer not in the manual?

Print Quality

maximum resolution	5760 X 1440 dpi
minimum ink droplet volume	3 pl

Print Speed

black text memo (A4)	Approx. 37 ppm (Draft) / 25 ppm (Default)
colour text memo (A4)	Approx. 20 ppm (Draft) / 11 ppm (Default)
photo (4R/4x6”)	Approx. 35 sec per photo (Draft W/Border)

Ink Cartridges

Paper Handling