EPSON Stylus Photo 925 Revision A
Troubleshooting Unit Level Troubleshooting 64
LD Roller attempt to load the
paper. But, paper is not loaded at
all.
Paper is not set
correctly. Set the
paper correctly; then
press the Roll Paper
button if using roll
paper, or press the
Maintenance button if
using sheet paper.
LD Roller 1. Check to see if paper dust is adhering to the surface of
the LD Roller.
1. Set a cleaning sheet in the ASF up side down.
Then holding the top edge, try to load the paper
from the Printer driver. The micro pearl on the
LD Roller surface is removed. To remove
severe smear, staple a cloth moistened with
alcohol to a post card and clean the roller in the
same manner.
* If the problem is not solved, replace the LD
Roller with a new one.
Table 3-6 Check Points for “Paper Out” Error(continued)
Observation LCD Indication
Unit/part in
Question
Check Points Remedy
LD Roller
Cleaning sheet
Post card as the base sheet
Non-adhesive
Adhesive area
This side down
Staple
Cloth wet with
alcohol
To Next Page
Loading...
