Loading and Cutting Roll
Paper
Loading Roll Paper
Using the roll paper holder, position the paper at the
rear of the printer. See the following for information on
supported roll paper types.
U “Supported Media” on page 107
A
Turn on the printer.
B
Open the front cover.
Tip:
If the front manual feed tray is open, push the
center of the tray to close it.
C
Fully extend the output tray.
D
After confirming that the end of the roll paper is
cut straight across, insert the supplied roll paper
holder into the ends of the roll.
If the end of the roll paper is not cut straight
across, trim it straight before proceeding.
E
Open the rear support.
Only open the support; there is no need to extend
it.
Epson Stylus Photo R3000 User's Guide
Basic Operations
26
To Next Page
Loading...
Need help?
General
Weight and Dimensions
