Epson STYLUS PRO 9400 - Page 24

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Product Description Basic Specifications 24
1.2.5.2 Borderless Printing Specifications
BORDERLESS PRINTING WIDTH
 The printer is capable of printing off both left and right edges of roll or cut sheet
media with widths shown in the table below.
Note • The borderless printing is not guaranteed for all types of media, and it cannot be made
properly under some conditions. See “Borderless printing guarantee conditions (p.25)”
for more information.
• Print data extend off the borderless printable area is automatically cut off.
BORDERLESS PRINTING MODE
The following borderless printing modes are supported by command transmission from
the driver.
Note "*1": When the roll paper cutter is OFF and cut line printing is ON, a cut line is printed on
each cut position including the one for cutting the top edge.
"*2": After the 4 sides borderless cut, the actual printed size is approximately 2mm smaller
in the vertical direction.
"*3": When roll paper borderless print for 4 sides is performed on the media types shown
below, irregular coloring may occur when the edges are cut.
• Double Weight Matte Paper
• Single Weight Matte Paper
• Enhanced Matte Paper
• Textured Fine Art Paper
• Ultra Smooth Fine Art Paper
Table 1-12. Paper Width
Size
Stylus Pro 7400/7800 Stylus Pro 9400/9800
inches mm
regular
size
10” 254mm --- {{
--- 300mm --- { {
13” 329mm A3+ {{
16” 406.4mm --- { {
17” 431.8mm --- {{
--- 515mm B2 { {
--- 594mm A1 {{
24” 609.6mm --- { {
--- 728mm B1 --- {
36” 914.4mm --- --- {
44” 1,117.6mm --- --- {
Table 1-13. Borderless Printing Mode
Mode Operation
Right/left borderless
(default) *
1
Left and right margins can be set to zero. In this case the upper and
lower margins are set by the roll paper margin settings.
4 sides borderless/
Single Cut *
1,
*
2,
*
3
Cuts the top and bottom edges in the way as described below to
create a printout without margins on all four sides:
• The top edge of the first page is cut off leaving “minimum cut
margin”.during the printing.
• No margin is created between pages and the printer cuts on the
boundary to separate the pages.
• The bottom edge of the last page is cut off after the printing is
complete.
4 sides borderless/
Double Cut *
1,
*
2,
*
3
Cuts the top and bottom edges in the way as described below to
create a printout without margins on all four sides.
• The top edge of the first page is cut off leaving “auto refresh
margin” during the printing.
• Each time printing one page is complete, the bottom edge is cut
off and the paper is fed a little (create a minimum cut margin
between pages), and the top edge of the next page is cut off
during printing. This mode is more accurate than the Single Cut
mode as it cuts the paper twice to separate pages.