Epson STYLUS PRO 9400 - Page 247

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 247
4. Disconnect the FFC from the CR Encoder Sensor connector.
5. Remove the screw that secures the CR Encoder Sensor and remove it.
 One C.B.P. M3 x 6 screw
Figure 4-66. Removing the CR Encoder Sensor
Set the two positioning holes of the CR Encoder Sensor onto the two
guide pins.
A D J U S T M E N T
R E Q U I R E D
Whenever the CR Encoder Sensor is reinstalled or replaced, the
corresponding adjustment must be carried out. See Chapter 5 on
page 292.
CR Encoder Sensor
Connector
FFC
Guide Pins
C.B.P. 3x6