Epson STYLUS PRO 9400 - Page 253

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 253
6. Remove the screw that secures each of the two SEAL, HOLDs, and remove them.
See Figure 4-77.
 Two C.C.S. M3 x 8 screws
7. Disconnect the three connectors of the VACUUM FAN ASSY. from the relay
connectors. See Figure 4-78.
8. Release the two relay harnesses from the five retaining clips (two clips on the
center, and three clips on the right side) of the VACUUM FAN ASSY. See Figure
4-78.
Figure 4-77. Removing the SEAL, HOLD
Figure 4-78. Releasing the Relay Harnesses
C H E C K
P O I N T
The SEAL, HOLD is not included in the Stylus Pro 7400/7800.
Route the two relay harnesses as shown in the figure below.
Figure 4-76. Releasing the Relay Harnesses
Center
Wind the relay harness to be connected to the left
VACUUM FAN ASSY. around the hooked tab.
Right Side
Wind the relay harness to be
connected to the left VACUUM
FAN ASSY. around the hooked tab.
Wind the relay harness to be
connected to the center VACUUM
FAN ASSY. around the hooked tab.
SEAL, HOLD
C.C.S. 3x8
Connector
Relay harness Relay harness
Center
Hooked tabs
Right Side
Hooked tabs