Epson STYLUS PRO 9400 - Page 268

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 268
6. Put the left retaining hook of the Damper Unit on the hole on the left bottom of the
CR COVER ASSY. to hang the Unit on the Assy. See Figure 4-104.
7. Loosen the right screw and remove the left screw that secure the HEAD FIXING
PLATE. See Figure 4-105.
 Two C.P.S.(S-P2) M3 x 6 screws
8. Release the HEAD FIXING PLATE from the tab and slide the right side of the
Plate toward you. See Figure 4-105.
Figure 4-104. Hanging the Damper Unit
Figure 4-105. Releasing the HEAD FIXING PLATE
Retaining Hook
Hole
CR COVER ASSY.
HEAD FIXING PLATE
Tab
Remove the C.P.S.(S-P2) M3x6 screw
Loosen the C.P.S. (S-P2) M3x6 screw