Epson STYLUS PRO 9400 - Page 326

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Adjustment Basic Adjustment 326
6. Remove the H Top Cover and move the Carriage Unit to the center.
7. Remove the two screws (A and B shown in Figure 5-40) that secure the Head
Fixing Plate and remove it.
8. Slightly move the H Adjust Lever up or downward to correct the inclination
of the printhead.
z A<B shown in Figure 5-38: Move the H Adjust Lever downward.
z A>B shown in Figure 5-38: Move the H Adjust Lever upward.
9. Tighten the A and B screws that are removed in Step 7 in that order.
10. Close the printer cover (half transparent) and temporary joint the cover.
11. Press the [Back] button to return to the Screen 1 (Figure 5-37) and click the
[Print] on the screen to print the adjustment pattern again. The Carriage Unit
automatically moves to the center upon finishing the printing.
12. Click the [Next] button. (Go to Screen 3)
13. Examine the printout patterns again following the instruction in Step 5. If the
result is NG, perform Step 6 to Step 13 again.
Figure 5-39. [Print Head Slant Adjustment (CR)] Screen (2)
Figure 5-40. Screws Securing the Head Fixing Plate and the H Adjust Lever
A
B
H Adjust Lever
Screws Securing the Head Fixing Plate
Head Fixing Plate