Epson STYLUS PRO 9400 - Page 73

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Product Description Control Panel 73

Manual Nozzle Check pattern
 Order of colors (Stylus Pro 7800 and Stylus Pro 9800: from left)
Light Light Black→Light Magenta→Light Cyan→Light Black→Photo Black
/ Matte Black→Cyan→Magenta→Yellow
Figure 1-15. Manual Nozzle Check Pattern (Stylus Pro 9800)
 Order of colors (Stylus Pro 7400 and Stylus Pro 9400: from left)
Matte Black x 2→Magenta x 2→Cyan x 2→Yellow x 2
Figure 1-16. Manual Nozzle Check Pattern (Stylus Pro 9400)
 Explanation of information printed under the pattern
 <Z>: 0 (other than “0” indicates special specification)
 <xxxx>: Firmware version
 I: Number of colors (four or eight) used for printing
 B: Business system setting
 C: Custom version setting
 S: Development stage
 <yyy>: Available space in the Maintenance Tank
 <aaaaa.a>: Ink consumption counter detected immediately before
printing the pattern. (5.1-digit)
 <bbbbb.b>: Ink consumption counter detected immediately before
printing the previous pattern. (5.1-digit)
 <ccccc.c>: Value obtained by subtracting <bbbbb.b> from <aaaaa.a>
(5.1-digit)
 <ddddd.d>: Paper consumption counter detected immediately before
printing the pattern (5.1-digit)
 <eeeee.e>: Paper consumption counter detected immediately before
printing the previous pattern (5.1-digit)
 <fffff.f>: Value obtained by subtracting <eeeee.e> from <ddddd.d>.
(5.1-digit)
NOTE • “-” is printed instead of ink or paper counter value if the corresponding
value does not exits.
• When printing the check pattern on Premium Glossy Photo Paper or
Premium Semigloss Photo Paper, the top margin is automatically set to 20
mm regardless of the margin setting made by the panel setting menu to
ensure proper print of the pattern.
Version :SW<Z><xxxx>.IBCS
MaintenanceTank Left:<yyy>% MaitenanceTank Right:<yyy>%
Cur.InkCount :<aaaaa.a>ml Pre.InkCount :<bbbbb.b>ml C-P:<ccccc.c>ml
Cur.PaperCount:<ddddd.d>cm Pre.PaperCount:<eeeee.e>cm C-P:<fffff.f>cm
Version :SW<Z><xxxx>.IBCS
MaintenanceTank:<yyy>%
Cur.InkCount :<aaaaa.a>ml Pre.InkCount :<bbbbb.b>ml C-P:<ccccc.c>ml
Cur.PaperCount:<ddddd.d>cm Pre.PaperCount:<eeeee.e>cm C-P:<fffff.f>cm