196
• Place the product on a flat, stable surface that extends beyond its base in all directions. It will not
operate properly if it is tilted or at an angle.
• Do not tilt the product more than 10 degrees in any direction while moving it. Doing so may cause the
product to fall and cause damage or personal injury.
• Do not attempt to move the product alone; four people are required to move the product.
• Do not attempt to move the product alone; four people are required to move the product
• Use correct posture when lifting the product.
• Make sure to remove all packing materials from the product and installation area.
• When placing the product on a stand with casters, make sure the casters are secured before you
perform any work so that they do not move. If the stand moves while you are performing any work, it
could cause an injury.
• Except when moving the product, keep all casters on the stand and ink unit locked at all times. Failure
to observe this precaution could cause accidents.
• When moving the product, make sure it is turned off, the power cables are unplugged from the outlets,
and all connecting cables have been removed. Avoid steps and uneven surfaces.
• Avoid locations that are subject to rapid changes in heat or humidity, shocks or vibrations, or dust.
• Do not place or store the product outdoors.
• Do not place the product near excessive heat sources or in direct sunlight.
• Leave enough room around the product for sufficient ventilation. Do not block or cover openings in the
cabinet or insert objects through the slots.
• Do not cover the printer with a cloth or install it in a location with poor ventilation.
• Keep the product away from potential sources of electromagnetic interference, such as loudspeakers
or the base units of cordless telephones.
• When connecting the product to a computer or other device with a cable, ensure the correct
orientation of the connectors. Each connector has only one correct orientation. Inserting a connector
in the wrong orientation may damage both devices connected by the cable.
• Do not touch the encoder strip (carriage scale) except when cleaning. Malfunctions may occur if it is
dirty or damaged.
• Do not put your hands inside the product and be careful not to trap your hands or fingers when
opening or closing the printer cover. Do not put your hands on the movable base.
• Do not disassemble anything except as indicated in the product's documentation.
To Next Page
Loading...
