62
10. Lift the part shown below and then loosen the fixing lever.
11. Lower the part you lifted and then tighten the fixing lever again to secure the platen gap lever.
Parent topic: Preparing Your Printer
Installing the Platen
After you have removed or attached spacers as necessary, you can install a platen on the printer.
1. Make sure the printer is off and the platen is ejected forward.
Turn on the printer and then press the moveable base button to move the platen forward, and then
turn off the printer, if necessary.
2. If you are replacing a platen, grip the left and right side of the platen and lift it straight up to remove it.
Note: If you are replacing a sleeve platen, remove the fixing band before lifting the platen.
To Next Page
Loading...
