45
6. Fix the pre-treatment solution with a heat press and parchment (silicone) paper.
Note: The T-shirt fibers must be pressed flat to produce even whiteness. Even if you use a heat
tunnel to fix the ink, use a heat press with parchment (silicone) paper to fix the pre-treatment solution
before printing.
Parent topic: Pre-treating a T-shirt
Related references
Fixing the Pre-treatment Solution (Heat Press)
Diluting the Pre-treatment Solution
Pre-treating a T-shirt with a Pre-treatment Machine
Since pre-treatment machine models may vary in operation and controls, you should consult the pre-
treatment machine documentation.
Warning: Depending on the type of sprayer used, the machine may create a mist when applying the
pre-treatment solution. Wear a mask, protective eyewear, and gloves, and make sure the area is well
ventilated. The solution mist could also enter the printer and cause a malfunction or damage the product.
If necessary, install the pre-treatment machine in a location away from the printer.
Note: Apply approximately 0.5 ounces (15 grams) of pre-treatment solution to printing areas of letter-
/A4-size. Do not apply too much pre-treatment liquid; otherwise, the print quality may decline.
1. Pour the diluted pre-treatment solution into the pre-treatment machine as directed by the
manufacturer.
2. Spread out the T-shirt on a flat surface.
3. Use sticky tape (or a lint roller) to remove lint from the area where you will apply the pre-treatment
solution.
To Next Page
Loading...
