71
5. Remove any lint from the printing surface and press the fibers flat.
Note: There may be lint on the T-shirt if you have not applied pre-treatment solution. Use a lint roller
or sticky tape to remove the lint and then press the fibers flat using a hard roller. Lint and fibers may
stick to the print head and stain other areas.
6. Remove any slack or creases from the printing surface and make it flat.
Note: The printer detects the highest part of the garment surface. If there are any wrinkles, creases,
or slack, a platen height error may occur or print quality may decline. Stretch the T-shirt to remove
the slack, however, do not stretch the T-shirt so much that the printed image will be distorted.
To Next Page
Loading...
