104
Serial Communication Device Registration
Use EPSON TMNet WebConfig to register a serial communication device with this product,
following the procedures below.
1
Run EPSON TMNet WebConfig from shortcut on the desktop.
EPSON TMNet WebConfig is started.
2
Select [Settings] - [Web service settings], then [Serial communication
device].
The "Serial communication device" screen is displayed.
3
Set the device ID. (Any character string)
If you perform settings from an external device, enter the following in the URL field
of your Web browser (such as the address bar).
http://"TM-DT’s IP address"/webconfig
The default "TM-DT's IP address" for this product is "192.168.192.168".
To Next Page
Loading...
