104
Receive Buffer
You can set the receive buffer of the TM-T88VI to 4KB or 45 bytes with DIP switch 1-2 as with the TM-T88V.
The buffer full condition and buffer full release condition of the TM-T88VI are the same as those of the
TM-T88V.
Memory Capacity
The sizes of the download buffer and NV graphics data of the TM-T88VI are the same as those of the
TM-T88V.
Electrical Characteristics
The operating voltage of the TM-T88VI is DC24 ± 7%, the same as the TM-T88V. The current consumption
differs, depending on the print duty. When you set the print speed to 350 mm/s, the amount of electricity
consumed increases.
DIP Switches
The functional assignments of DIP switches for the TM-T88VI differ from the TM-T88V. See "Setting the DIP
Switches" on page 55
for more details.
Printer Status
The TM-T88VI goes to the same status under the same conditions as the TM-T88V. You can replace the
TM-T88V with the TM-T88VI without modifying applications.
Logo Registration
The TM-T88VI can register logos in the NV memory (NVRAM) with the Setup Utilities.
Driver Compatibility
You can operate the TM-T88VI with a driver for the TM-T88V.
USB Low Power Consumption Mode
With the TM-T88VI, you can enable the USB low power consumption mode in the software setting mode.
To Next Page
Loading...
