126
When the printer is turned on
When the signal is dropped and then restored
The following shows the printer operations and connection methods when the auto reconnect feature is enabled
or disabled.
* In the following situations, even if the feature is enabled, the same operations are performed as when it is
disabled.
- When pairing is canceled from the connected iOS device.
- When the last Bluetooth device connected was not an iOS device.
- When wireless communication settings are initialized from the printer.
* Disable this feature when using the printer from devices that are not running iOS. Otherwise, it may take
some time to connect.
* For details on the Auto Reconnect Feature, see "Interface Setup Mode" on page 77
.
Notes on use
Time required until printing starts
If the host computer and the printer are not connected on a continuous basis but rather connected every time
the printer starts printing, some time may be needed for the printer to actually start printing after the host
computer commands printing. This pause is the time required for processing the connection between the host
computer and the printer.
After opening the port, leave an interval of 300 msec or more before sending data to the port.
Auto Reconnect
Feature
Enabled Disabled
Printer operations
when Bluetooth is
disconnected
Perform the following reconnection
sequence.
[Reconnection sequence]
1.The printer tries to connect to the iOS device
to which it was last connected.
2.When step 1 fails, the printer waits for
connections from other devices.
3.If connection is not established in step 2, the
printer tries again to connect to the iOS
device to which it last connected.
Steps 1 and 2 are repeated until a
connection is established.
Wait for a connection from the Bluetooth
device.
Reconnecting to iOS
device
Reconnect automatically. Make settings on the Bluetooth settings screen
on the iOS device.
Switch to connection
from other device
Method 1:
After disabling the Bluetooth feature of the connected iOS device, make connection settings on
the Bluetooth device that you want to connect.
(When the auto reconnect feature is enabled, it may take some time to connect.)
Method 2:
After disconnecting from the connected iOS device using applications with the Epson TM Utility
for iOS or Epson ePOS SDK disconnection feature, make settings on the Bluetooth device you
want to connect.
To Next Page
Loading...
