Epson TM-T88VI - Page 63

63
Chapter 3 Advanced Usage
3
 Enabled
Line space reduction rate
 Not reduced (default setting)
 Reduce 25%
 Reduce 50%
 Reduce 75%
Line feed reduction rate
 Not reduced (default setting)
 Reduce 25%
 Reduce 50%
 Reduce 75%
Amount of reduction in character height
 Not reduced (default setting)
 Reduce 25%
 Reduce 50%
 Reduce 75%
Amount of reduction in barcode height
 Not reduced (default setting)
 Reduce 25%
 Reduce 50%
 Reduce 75%
Amount of top margin by backfeed
Selectable from levels 15 mm ~ 2mm (0.5 mm interval)
Default setting: level 15 mm
Auto paper feed&cut at cover close
 Cuts
 Does not cut (default setting)
 Remove all ejected paper before printing with backfeed.
 Disable the automatic top logo setting when enabling backfeed.
 You cannot use backfeed in the following cases even if you have enabled backfeed.
 Immediately after auto cutting while the cover is closed.
 While the self-test is in progress.
 You can specify values in 0.5mm steps if you use Setup Utilities.