To Next Page

To Previous Page

Rev. A Setup 3-5

TM-U220II Technical Reference Guide

The following sections describe the setup. The flow of preparing to use printer is listed below.

1. Printer setup

Install Ribbon Cassette

(“Installing or Replacing the Ribbon Cassette” (page 3-6))

Install Paper Roll (“Installing the Roll Paper” (page 3-7))

 Connect the Priner to the Power Supply

(“Connecting the Power Supply Unit” (page 3-13))

 Connecting an Optional External Buzzer

2. Adjust various setting ( If you need to)

When you use this printer with a serial interface, you have to adjust the communication

settings. See “Adjusting the DIP Switches” (page 3-15) and “Memory Switches” (page 3-

20) for how to set them.

DIP switches (“Adjusting the DIP Switches” (page 3-15))

The DIP switches set serial communication conditions, busy condition,

print column, receive buffer capacity, etc...

Memory switches (“Memory Switches” (page 3-20))

The Memory switches set serial communication conditions,

roll paper width, cover open status handling, etc...

 Paper width (“Adjusting Roll paper width” (page 3-28))

The paper width is set by the spacer & Memory switch setting.

 Roll Paper Near End Detector (For model equipped with the detector)

(“Adjusting Position of Roll Paper Near End Detector” (page 3-29))

3. Connect the Pritner to the Host PC/POS Terminal (and Cash Drawer)

(“Connecting the Printer to the Host PC / POS Terminal” (page 3-30))

4. Driver set up (If you use driver)

(“Install a Printer Driver in the Host PC / POS Terminal” (page 3-33))

5. Complete the setup

Epson TM-U220II Technical Reference Guide

Other manuals for Epson TM-U220II