Rev. A Setup 3-33
TM-U220II Technical Reference Guide
3.4.7.5 Connecting a Drawer
CAUTION:
Be sure to connect a drawer that meets printer specifications. Connecting a drawer of
the wrong specifications may result in damage to both the drawer and the printer.
Never connect the telephone line to the drawer kick connector (labeled “DK”). Doing
so may result in damage to both the telephone line and the printer.
Never connect the drawer cable to the customer display connector (labeled “DM-D”).
Doing so may result in damage to both the drawer cable and the printer.
1. Connect the drawer cable to the drawer kick connector (labeled “DK”) on the connector
panel.
Connecting drawer
2. The connecting is finished.
3.5 Install a Printer Driver in the Host PC / POS Terminal
See the corresponding printer driver manual for printer driver installation procedures.
3.6 Self Test
The self test lets you know if your printer is operating properly. It checks the control circuits,
printer mechanisms, print quality, control software version, and DIP switch settings.
This test is independent of any other equipment or software, so it is a good idea to run it when
you first set up the printer and if you have any trouble. If the self tests work correctly, the
problem is in the other equipment or the software, not the printer.
3.6.1 Self Test Procedure
1. Make sure the printer is turned off and the roll paper cover is closed properly.
To Next Page
Loading...
