Epson TM-U220II - 6.1.2 Cutting method

Rev. A Notices for Replacement of the TM-U210/TM-U220/TM-U300 6-3
TM-U220II Technical Reference Guide
6.1.2 Cutting method
The left uncut position for partial cutting of the TM-U220II (Type A and B) is different than the
TM-U210 in that it is on the right edge. The TM-U210 always uses a partial cut method in which
there is one point left uncut on the left edge at the center position.
Cutting methods of the TM-U220II (Type A and B) and TM-U220 (Type A and B ) are the same.
TM-U210 (Type A, B, and D)
TM-U220/TM-U220II (Type A and B)
Print start position line
Auto cut position line
Manual cut position line
27 mm
34.9 mm
Paper feed direction
Print start position line
Manual cut position line
22.1 mm
Paper feed direction
These values are reference values.
(When using 76-mm roll paper)
TM-U220/TM-U220II (Type D)
(When using 76-mm roll paper)
Print start position line
Manual cut position line
22.1 mm
Paper feed direction