Rev. A Notices for Replacement of the TM-U210/TM-U220/TM-U300 6-1
TM-U220II Technical Reference Guide
Chapter 6
Notices for Replacement of the TM-U210/TM-U220/TM-U300
The TM-U220II is designed to smoothly replace the TM-U220/TM-U210/TM-U300. This section
provides answers to your questions during replacement.
6.1 For TM-U210/TM-U220 Replacement
When you replace TM-U210 with theTM-U220II, you have to set the memory switches
[MemSW8-5: OFF (default)] and [MemSW 8-8: OFF (default)] to maintain the same status
provided by TM-U210. See “Provided statuses” (page 6-5) for details.
6.1.1 Printing format compatibility
This section describes the printing area, character, and top margin (cutting position)
compatibilities.
6.1.1.1 Printing area
The TM-U220II has almost the same printing area as the TM-U210 as shown in the following
table and figures. Additionally, the TM-U220II and TM-U220 have the same printing areas.
Therefore, the TM-U220II can print the same contents as the TM-U220/TM-210 without any
special adjustment of settings.
Printing area and margins
Printing area item TM-U210 (Type A, B, and D) TM-U220/TM-U220II (Type A, B, and D)
(when using 76-mm width paper)
Print width 63.34 mm
(200 dots, 400 position)
63.34 mm
(200 dots, 400 position)
Left margin 5.9 mm 6.8 mm
Right margin 6.76 mm 5.8 mm
76 mm
63.34 mm
6.76 mm
5.9 mm
Printable area
76 mm
63.34 mm
6.8 mm
5.8 mm
Printable area
TM-U210
TM-U220/TM-U220II (When using 76-mm roll paper)
These values are reference values.
To Next Page
Loading...
Need help?
General