Epson TM-U220II Technical Reference Guide

6-12 Notices for Replacement of the TM-U210/TM-U220/TM-U300 Rev. A
6.2.2 Cutting method
For the TM-U300, you can select the partial cut method from Driver or ESC/POS command
control. There are two partial cut methods. One is a three points left uncut method and the other
is one point left uncut on the left edge.
The TM-U220II (Type A and B) allows you to select Partial cut (one point is left uncut on the
right edge).
6.2.3 Dimensions
The dimensions of the TM-U220II (except for Type D) are somewhat smaller than the TM-U300,
such that the TM-U220II can be installed in the same space as the TM-U300.
See “External Dimensions and Mass” (page 1-14) for details.
6.2.4 Receive buffer size
This section applies to the serial model.
The receive buffer size of the TM-U220II can be changed as shown in the following table.
TM-U300 TM-U220II
Dimensions
(W x D x H)
Type A: 170 x 288 x 183 160 x 286 x 158
Type B: 170 x 253 x 148 160 x 248 x 139
Type C: 158 x 295 x 145 --
Type D: 158 x 235 x 125 160 x 248 x 139
Product Receive buffer capacity Buffer full
condition
Buffer full
release
condition
Number of bytes from buffer
full to release full state
TM-U300 40 bytes
(DIP SW1-2 is on)
(ANK: DIP SW1-2 is off)
1 KB
(Multilingual: DIP SW1-2 is off)
512 bytes
Buffer space is
10 bytes
Buffer space is
20 bytes
10 bytes
TM-U220II 40 bytes
(DIP SW1-2 is on)
Buffer space is
16 bytes
Buffer space is
26 bytes
10 bytes
4 KB
(DIP SW1-2 is off)
(default)
Buffer space is
128 bytes
Buffer space is
256 bytes
128 bytes

Epson TM-U220II Specifications

General

Brand	Epson
Model	TM-U220II
Category	Printer
Language	English