v Rev. A
• Do not place cord near heating equipment.
• Check that the plug is clean before plugging it in.
• Be sure to push the prongs all the way in.
❏ If the cord becomes damaged, obtain a replacement from your dealer or qualified
service personnel.
CAUTION:
❏ Do not connect cables other than as described in this manual. Different
connections may cause equipment damage and burning.
❏ Be sure to set this equipment on a firm, stable, horizontal surface.
Product may break or cause injury if it falls.
❏ Do not use in locations subject to high humidity or dust levels.
Excessive humidity and dust may cause equipment damage, fire, or shock.
❏ Do not place heavy objects on top of this product. Never stand or lean on this
product. Equipment may fall or collapse, causing breakage and possible injury.
❏ To ensure safety, please unplug this product prior to leaving it unused for an
extended period.
❏ Do not touch either the thermal or the dot matrix print head or the paper feed
motor. Wait for the heads and the motor to cool. The head and the motor can be
very hot after printing for a long time. Touching them may cause burns.
❏ Using in the presence of silicon gas (silicon adhesive, silicon oil, silicon powder, etc.)
including siloxane and of malignant gas (nitric acid, hydrosulfuric, ammonia,
chlorine, etc.) may cause contact failure at contact points in a mechanical switch
and a DC motor etc. in a short time because of adhesion or oxidization of the
insulation film.
To Next Page
Loading...
Need help?
General