Epson TM-U295

EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
F
TM-U295/U295P
Specification
(STANDARD)
47 46
ESC =
n
[Name] Select peripheral device
[Format] ASCII ESC =
n
Hex 1B 3D
n
Decimal 27 61
n
[Range] 0
£
n
£
3
[Description] Selects the device to which the host computer sends data, using
n
as follows:
Selects the peripheral device for which subsequent data is effective, according to the
value set for “
n
”.
ù
Each bit of “
n
” is described in the table below.
ù
If “printer disables” is selected, the printer ignores all received data until “printer
enabled” is selected by this command.
Bit Off/On Hex Decimal Function
Off 00 0 Printer disabled.0
On 01 1 Printer enabled.
Off -- -- Undefined.1
On -- -- Undefined.
Off -- -- Undefined.2
On -- -- Undefined.
Off -- -- Undefined.3
On -- -- Undefined.
Off -- -- Undefined.4
On -- -- Undefined.
Off -- -- Undefined.5
On -- -- Undefined.
Off -- -- Undefined.6
On -- -- Undefined.
Off -- -- Undefined.7
On -- -- Undefined.
[Note]
ù
Even if the printer disabled is selected, it goes off-line due to printer operation. (Refer
to Section 2.1.1.2).)
[Default]
n
= 1