Epson TM-U295

EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
F
TM-U295/U295P
Specification
(STANDARD)
56 55
ESC c 3
n
[Name] Select paper sensor(s) to output paper end signals
[Format] ASCII ESC c 3
n
Hex 1B 63 33
n
Decimal 27 99 51
n
[Range] 0
£
n
£
255
[Description] Selects the paper sensor(s) to output paper end signals.
ù
Each bit of
n
is used as follows:
Bit Off/On Hex Decimal Function
Off -- -- Undefined.0
On -- -- Undefined.
Off -- -- Undefined.1
On -- -- Undefined.
Off -- -- Undefined.2
On -- -- Undefined.
Off -- -- Undefined.3
On -- -- Undefined.
Off 00 0 TOF sensor disabled.4
On 10 16 TOF sensor enabled.
Off 00 0 BOF sensor disabled.5
On 20 32 BOF sensor enabled.
Off -- -- Undefined.6
On -- -- Undefined.
Off -- -- Undefined.7
On -- -- Undefined.
[Notes]
ù
It is possible to select multiple sensors to output signals. Then, if any of the sensors
detects a paper end, the paper end signals is output.
ù
This command is available only with a parallel interface model and is ignored with a
serial interface model.
[Default]
n
= 0
54-255