Epson TM-U295

EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
F
TM-U295/U295P
Specification
(STANDARD)
67 66
GS a
n
[Name] Enable/disable Automatic Status Back (ASB)
[Format] ASCII GS a
n
Hex 1D 61
n
Decimal 29 97
n
[Range] 0
£
n
£
255
[Description] Enables or disables ASB and specifies the status items to include, using
n
as follows:
Bit Off/On Hex Decimal Function
Off 00 0 Drawer kick-out connector pin 3 status disabled.0
On 01 1 Drawer kick-out connector pin 3 status enabled.
Off 00 0 On-line/Off-line status disabled.1
On 02 2 On-line/Off-line status enabled.
Off 00 0 Error status disabled.2
On 04 4 Error status enabled.
Off -- -- Undefined.3
On -- -- Undefined.
Off -- -- Undefined.4
On -- -- Undefined.
Off 00 0 Slip sensor status disabled.5
On 20 32 Slip sensor status enabled.
Off -- -- Undefined.6
On -- -- Undefined.
Off -- -- Undefined.7
On -- -- Undefined.
[Notes]
ù
The ASB function is disabled if no status is selected.
ù
If any of the status items in the table above are enabled, the printer automatically
transmits 4 status bytes whenever the enabled status item changes.
ù
If ASB is enabled while processing this command, the current status is transmitted with
no regulations.
ù
Status data which can be transmitted are shown in the table below.
ù
The 4 status bytes are transmitted without checking DSR.
ù
The 4 status bytes must be consecutive, except for XOFF code.