Epson TM-U295

EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
F
TM-U295/U295P
Specification
(STANDARD)
68 67
ù
Since this command is stored in the receive buffer and then executed during normal
command process, there may be a time lag between command reception and status
transmission, depending on the receive buffer status.
ù
When the printer disabled is selected using
ESC =
, this command is disabled, but the
ASB is always enabled.
ù
When any of
DLE EOT, ESC u, ESC v,
or
GS I
is used, the status transmitted by these
commands and the ASB status must be differentiated by using the table in Appendix D.
À
First byte (printer information):
Bit Off/On Hex Decimal Status for ASB
0 Off 00 0 Not used. Fixed to Off.
1 Off 00 0 Not used. Fixed to Off.
Off 00 0 Drawer kick-out connector pin 3 is LOW.2
On 04 4 Drawer kick-out connector pin 3 is HIGH.
Off 00 0 On-line.3
On 08 8 Off-line.
4 On 10 16 Not used. Fixed to On.
5 Off -- -- Undefined.
Off 00 0 Paper is not being fed by the paper feed button.6
On 40 64 Paper is being fed by the paper feed button.
7 Off 00 0 Not used. Fixed to Off.