Epson TM-U295

EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
F
TM-U295/U295P
Specification
(STANDARD)
70 69
Ã
Fourth byte (paper sensor information):
Bit Off/On Hex Decimal Status for ASB
0 Off 00 0 Slip paper selected.
Off 00 0 Slip printing possible.1
On 02 2 Slip printing not possible.
Off -- -- Not used.2
On -- -- Not used.
Off -- -- Not used.3
On -- -- Not used.
4 Off 00 0 Not used. Fixed to Off.
Off -- -- Undefined.5
On -- -- Undefined.
Off -- -- Undefined.6
On -- -- Undefined.
7 Off 00 0 Not used. Fixed to Off.
Bit 1:
ù
Becomes 1 (printing not possible) when printing is carried out by
FF
or paper is
ejected.
ù
If
ESC c 4
(slip paper-end stop) is not selected, bit 1 does not become 1 (printing
not possible). If
ESC c 4
is selected, bit 1 becomes 1 (printing not possible)
when paper-end is detected by the sensor.
ù
When the printer goes to the slip wait status, bits 5 and 6 of the third byte
become 1 (paper-end) and bit 1 of the fourth byte becomes 1 (printing not
possible).
[Default]
n
= 0
[Reference]
DLE DOT, ESC u, ESC v
Appendix D,
Transmission Status Identification